HEIDENHAIN CNC Pilot 4290 - Manual (Page 224)

5 Graphic Simulation 212
5.9 Time Calculation
During machining or motion simulation, the CNC
PILOT calculates the productive and non-productive
times.
Call: ”Settings - Times” menu item
Exit the time calculation
The machining times, idle times and total times are
shown in the table ”Time calculation” (green:
machining times; yellow: idle times). Each line
represents the use of a new tool (for each tool call
withT).
If there are more table entries than fit on a screen
page, you can call further time data with the arrow
keys and PgUp/PgDn.
In control parameters 20 and 21 you can
define which control parameters will be
included in the time calculation.
5
.9
Time Calculation
Soft keys
Switch to the next slide
Output of the time calculation table on a printer (see
control parameter 40).
Call the ”synchronous point analysis”