HEIDENHAIN CNC Pilot 4290 - Manual (Page 64)

3 Manual Control and Automatic mode 52
Continued
3.6 Machine Display
Display elements
Position display (actual value display)
Distance from tool point to tool zero point
■ Empty box: Reference mark in this axis not yet traversed
■ White axis letter No enabling
Position display (actual value display) C
Position of the C axis.
■ ”Index”: Indicates the C axis „0/1“
■ Empty box: C axis is not active
■ White axis letter: No enabling
Distance-to-go display
Distance remaining in the current traverse command
■ Bar graphic: Distance to go in millimeters
■ Box at lower left: Actual position
■ Box at lower right: Distance to go
T display – without tool life monitoring
■ T number of active tool
■ Tool compensation values
T display – with tool life monitoring
■ T number of the active tool
■ Tool life data
3.6 Machine Display
The machine display of the CNC PILOT can be
configured. Per slide, you can configure up to 6
displays in Manual mode and Automatic mode.
Switches to the ”next configured
display”
To switch to the display of the following
slide, press the Change slide key. With
the spindle change key you can display
the next spindle.
The ”display elements” table explains the standard
display fields. For more display fields, see ”
7.3 Control
Parameters”
You can set the values of the Position
display in ”Display setting” (machine
parameter 17):
■ 0: Actual values
■ 1: Lag
■ 2: Distance to go
■ 3: Distance between tool tip and position
of slide
■ 4: Slide position
■ 5: Distance between reference cams
and zero pulse
■ 6: Nominal position value
■ 7: Distance between tool tip and slide
position
■ 8: IPO nominal position