Control panel connectors – Grass Valley XtenDD DD User Manual
Page 85

J19 b
Port 2
J19 a
Wipe Panel Connectors
Display Panel Connector
AUX Panel Connectors
WIPE SELECTION
DC POWER IN
AUX SELECTION
DC POWER IN
PC Keyboard
PS2 Mouse
Not part of delivery
Cable set RC 2144 (1.2m)
Cable set RC 2214 (2.5m)
Cable set RC 2144 (1.2m)
Cable set RC 2214 (2.5m)
PANEL LINK INPUT
J14
J13
AUX PANEL
WIPE PANEL
AC Power in 2
DC Power out
Auxiliary DC out
12V
50/60Hz
50/60Hz
AC Power in 1
J11
2A
+
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Caution: This unit has two power cords. To prevent electric shock disconnect both power
cords before servicing.
Attention: Cet appareil comporte deux cordons d’alimentation. Rafin de prevenir les choc
électriques, débrancher les deux cordons d’alimentation avant de faire le depannage.
Vorsicht: Dieses Gerät hat zwei Netzkabel. Vor Servicearbeiten beide Netzkabel entfernen.
Gefahr des elektrischen Schlags.
Caution: See installation manual before
connecting to the supply.
Attention: Lisez le manuel avant
l’installation d’alimentation.
Vorsicht: Vor Anschluß an das Netz
Installationsanleitung beachten.
J12
J15
100−240V; 2,5Amax;
100−240V; 2,5Amax;
R
Caution: Do not remove any cover. Risk of electrical shock. High current level.
No user serviceable parts inside. Refer servicing to qualified service personnel.
Available energy >240VA.
Attention: Ne pas enlever cette plaque. Tension dangereuse. Prière de s’adressera
au personnal qualifié. Alimentation >240VA.
Öffnen nur durch ausgebildetes Servicepersonal. Verfügbare Energie >240VA.
Achtung: Abdeckung nicht entfernen. Gefährliche Spannungen. Hohe Stromstärken.
PE
Modem
J22 b
Wipe selection
Aux selection
J23 b
J23 a
J22 a
GPI/
GPI/GPO
Port 5
Port 4
Port 6
Port 3
LAN
Port 1
J20 a
J20 b
J21 a
J21 b
RS 422 / RS 485
RS 232
Interface
Ω
Control panel
J17
J18
IPC-LAN
J10
* Note:
The panel link cable has to be mounted with angle
brackets, see the section 5.3.2 mounting the panel link
cable.
Keyboard
COM 1
SCSI
Panel link output
PS/2 Mouse
VGA
LAN
J1
J3
J5
J6
J7
J8
J9
COM 2
J2
TOUCH SCREEN
CONTROL
Control Panel
Connectors
Touch screen control cables:
Cable 1.8m, order no. 5 136 391 008
Cable 6.0m, order no. 3 119 100 304
*
Panel link cable RC 2146 1m,
order no. 3 119 100 313
50 W Terminator
XtenDD network
alternative
BNC T-type
BNC T-type
connector
connector
Cat 5 cabling (RJ45)
BNC cabling
Since hardware index 14 of panel controller
a RJ45 connector is equiped
Mini Switch
part of delivery
5. Connection and Startup
5 - 23
Planning and Installation - Rev. 3 / 04.2005
5.4.2
PANEL SET RPS35-3 / RPS35-4/32