Grass Valley XtenDD DD User Manual

Page 157

7. Initial Installation

7 - 27

Planning and Installation - Rev. 3 / 04.2005

Pos.

Function

Factory adjust.

T19

T23

G10

G11

G12

G13

T31

T33

G14

G15

R56

T10

T17

T22

T6 ... T25

T28

LED green

VCC OK, norm=on

LED red

<4.95V, norm=off

LED red

VBAT FAILure (Battery defective)

LED red

TEMP FAILure (temp to high)

LED red

ALARM, norm=off

Reset RSE processor

Test program RSE processor

LED red

SLAVE ERROR, norm=off

(lit during Reset an HW test)

LED red

INIT FAILure RSE, norm=off

Reset Host processor

Test program host processor

LED red

Master ERROR, norm=off

(lit during Reset an HW test)

LED red

INIT FAILure Host, norm=off

LED yellow

LAN ACCess, blinking

LED yellow

DMA ACCess (not in use)

LED yellow

GENLOCK locked, norm=on

The two thumbwheel switches on the front select the last

byte of the Ethernet (hardware) address of the device on

the LAN. Per factory preset this also forms the last byte

of the IP address.

LED yellow

ISPL (factory: PLD programming OK)

LED yellow

BSCAN (factory: BSCAN OK)

Threshold for 4.95V

FLASH/EPROM

BATT ON/OFF

see GPI Configuration

DIL switches (low byte):

Sw1-3 not used

Sw4

1 = internal use (not used from software V2.1.1)

Sw 5-8 not used

EPROM