Grass Valley XtenDD DD - Manual (Page 57)

4. Installing Control Panels
4 - 19 Planning and Installation - Rev. 3 / 04.2005
4.3 INSTALLING PANELS
WARNING!
With the standard modules installed, the basic panel weights 50 kg
(110 lbs). During installation and until secured in the desk, use an appropriate
lifting device to lift and support the main panel. Failure to follow this precau-
tion can result in injury to personnel and damage to equipment.
WARNING!
The control panels do not contain any control elements or switches required
for operation of the switcher. For this reason, the control panel should not
be opened by unauthorized persons and should always be locked.
The panel must be opened by authorized service personnel only!
Prior to opening the panel make sure that there are no objects on the panel,
such as pens, screwdrivers or other tools. When opening the panel, they
might fall into the device and cause disturbances.
Please close the control panel slowly. Do not let it drop!
CAUTION!
Control Panel hinges may not be adequate to hold panel in the open position
if mounted at more than 15 degrees.
ATTENTION!
RPD 35-2 display with rigid stand:
Please open the panel only to such an extend that the display will not be dam-
aged at the slanted part of the desk!
RPD 35-2 Display with tiltable stand:
Prior to opening the panel, tilt the display as a precaution to the front!