Grass Valley XtenDD DD - Manual (Page 83)

J19 b Port 2
J19 a
Modem J22 b Wipe selection
Aux selection
J23 b
J23 a J22 a GPI/ GPI/GPO Port 5
Port 4 Port 6
Port 3
LAN
Port 1 J20 a
J20 b
J21 a
J21 b
RS 422 / RS 485 RS 232 Interface
Ω
Control panel
J17 J18
50 W Terminator
XtenDD network
alternative
PC Keyboard
PS2 Mouse
Not part of delivery
BNC T-type BNC T-type
connector connector
PANEL LINK INPUT
J14 J13
AUX PANEL WIPE PANEL
AC Power in 2
DC Power out Auxiliary DC out
12V
50/60Hz 50/60Hz
AC Power in 1
J11
2A
+
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation. Caution: This unit has two power cords. To prevent electric shock disconnect both power
cords before servicing.
Attention: Cet appareil comporte deux cordons d’alimentation. Rafin de prevenir les choc
électriques, débrancher les deux cordons d’alimentation avant de faire le depannage.
Vorsicht: Dieses Gerät hat zwei Netzkabel. Vor Servicearbeiten beide Netzkabel entfernen.
Gefahr des elektrischen Schlags.
Caution: See installation manual before
connecting to the supply.
Attention: Lisez le manuel avant
l’installation d’alimentation.
Vorsicht: Vor Anschluß an das Netz
Installationsanleitung beachten.
J12 J15
100−240V; 2,5Amax; 100−240V; 2,5Amax;
R
Caution: Do not remove any cover. Risk of electrical shock. High current level.
No user serviceable parts inside. Refer servicing to qualified service personnel.
Available energy >240VA.
Attention: Ne pas enlever cette plaque. Tension dangereuse. Prière de s’adressera
au personnal qualifié. Alimentation >240VA.
Öffnen nur durch ausgebildetes Servicepersonal. Verfügbare Energie >240VA.
Achtung: Abdeckung nicht entfernen. Gefährliche Spannungen. Hohe Stromstärken.
PE
IPC-LAN
J10
Display Panel Connector
* Panel link cable for stand-alone display:
- with rigid stand, cable RC 2271 0.3m,
order no. 0 351 752 700
- with tiltable stand, cable RC 2216 5m,
order no. 0 351 0 351 747 200
* Panel link cables for
standard version display:
Cable RC 2146 1m, order no. 0 351 744 800
Cable RC 2216 5m, order no. 0 351 747 200
RS-422 Cable
(Option)
* Note:
The panel link cable has to be mounted with
angle brackets, see the section 5.3.2
mounting the panel link cable.
Keyboard COM 1
Panel link output PS/2 Mouse
VGA LAN
J1 J3
J5 J6 J7 J8
COM 2
J2
Control Panel
Connectors
TOUCH SCREEN
CONTROL
SCSI
J9
Touch screen control cables:
Cable 1.8m, order no. 5 136 391 008
Cable 6.0m, order no. 3 119 100 304
Cat 5 cabling (RJ45)
Mini Switch
part of delivery
Since hardware index 14 of panel controller
a RJ45 connector is equiped
BNC cabling
5. Connection and Startup
5 - 21 Planning and Installation - Rev. 3 / 04.2005
5.4 PANEL INTER-UNIT CABLING
5.4.1 PANEL SET RPS35-2