Grass Valley XtenDD DD - Manual (Page 165)

7. Initial Installation
7 - 35 Planning and Installation - Rev. 3 / 04.2005
Pos. Function Factory adjust.
G31...46
G16
G17
G18
G19
G20
G21
G22
G13
G14
G15
G49
Status LEDs
LED red 4.95V
LED green VCC OK
LED red VBATT LOW
LED red INIT FAIL
LED red BOOT ERROR
LED red DRAM ERROR
LED red LAN ACC
LED yellow BSC PROG
LED yellow BSC TEST
LED yellow ISPL PROG
LED yellow ISPL BSC
R130 4.95V threshold adjust
C54 Real Time Clock adjust
T8 - T13 GPI configuration, see description below
T14 LAN configuration INT (COAX)
T16 FLASH/EPROM EPROM
T22 BATT ON/OFF ON
T21 Internal use BSC Test
T29 Internal use BUSY
T25 High
T26 Low
Ethernet Address setup (least significant byte). This is also the LSB of
the IP address (default).
see final test
report
T27 DIL switches (high byte):
Sw1 0 = execute startup script
1 = do not execute startup script
Sw2 0 = start normal
1 = start verbose
Sw3 0 = normal boot
1 = boot via LAN
Sw4 1 = internal use (not used from software V2.1.1)
Sw5 not used
Sw6 not used
Sw7 not used
Sw8 1 = Joystick activated
0
0
0
1 (0)
1
T28 DIL switches (low byte):
Sw1 not used
Sw2 1 = Highlight
Sw3 1 = Lowlight
Sw4 Button lamp 0 = PCB’s Rev. 2
1 = PCB’s Rev. 1
Sw5-8 Panel type 0000 = RPD 35/32 (LX)
0001 = RPD 35/24 (L)
010x = RPD 35/3
011x = RPD 35/2
0100 = RPD 35/2S
“x” don’t care
1
0