Grass Valley XtenDD DD - Manual (Page 167)

7. Initial Installation
7 - 37 Planning and Installation - Rev. 3 / 04.2005
Pos. Function Factory adjust.
G3...18
G19
G20
G21
G22
G23
G24
G25
Status LEDs
LED red 4.95V not OK, norm=off
LED green VCC OK, norm=on
LED red VBAT FAILure (Battery defective)
LED red INIT FAILure, norm=off
LED red HOST ERROR, norm=off
LED yellow LAN ACCess, blinking
LED red TEMP FAILure (temp too high)
G26
G27
G28
LED yellow BSCAN (factory: BSCAN OK)
LED yellow BSC TEST (factory: BSCAN OK)
LED yellow ISPL (factory: PLD programming OK)
G30
G31
LED red PC POWER FAILure OK, norm=off
LED red PC RESET, norm=off
R12 Threshold for 4.95V
T2-T7 GPI configuration, see description below
T18 FLASH/EPROM EPROM
T19 BATT ON/OFF ON
T30 FLASH PROGR/OPERATION OPERATION
T26
T27
The two thumbwheel switches on the front select the last byte of
the Ethernet (Hardware) Address of the device on the LAN. Per
factory preset this also forms the last byte of the IP address.
see final test
report
T28 Test program processor
T29 Reset processor
T14 DIL switches (high byte):
Sw1 0 = execute startup script
1 = do not execute startup script
Sw2 0 = start normal
1 = start verbose
Sw3 0 = normal boot
1 = boot via LAN
Sw4 1 = internal use (not used from software V2.1.1)
Sw5 not used
Sw6 not used
Sw7 not used
Sw8 not used
0
0
0
1 (0)
T15 DIL switches (low byte):
Sw1 not used
Sw2 not used
Sw3 not used
Sw4 Button lamp 0 = PCB’s Rev. 2
1 = PCB’s Rev. 1
Sw5-8 Panel type 0000 = RPD 35/32 (LX)
0001 = RPD 35/24 (L)
0