Grass Valley CR Series v.3.2 - Manual (Page 71)

59
CR Series
User’s Guide
Mode Rotary Switch
The 16-position ‘Mode’ rotary switch configures the router’s video format. Set the rotary switch
to a position in the range 0–9, A, B, C, or D, according to this table:
The default is 1080i, 59.94 Hz (switch setting 0). Positions E and F are not valid positions.
Where a switch setting supports multiple formats, the format is governed by the video reference
applied to the router and must be compatible with that reference format.
 Every time you make a switch change, power-cycle the router.
Frame ID Rotary Switch
You must set up the IP addresses for the router (and a remote panel, if you have one). First, use
the rotary switch on the router (and remote panel module) to set an initial IP address:
For a CQX router,
address = switch value + 200.
The default IP address is 192.168.2.address.
Thus, address ranges from 201 to 215. However, use only a switch setting in the range 1–4
(addresses 201 to 204).
For remote panel modules,
address = switch value + 50.
The default IP address is 192.168.2.address.
Here, address ranges from 51 to 65.
The numbers on the rotary switch are in hexadecimal: 0–F. Do not use 0 because 0 causes
the router or remote panel module to be reset.
After you perform the setup using the rotary switches, you can use CRSC to change the IP
addresses from the defaults.
 Every time you make a switch change, power-cycle the router or remote panel module.
Setting Format Setting Format
0 1080i, 59.94 or 60
1080p, 29.97 or 30
1080psf, 29.97 or 30 6 1080p, 59.94 or 60 Switch positions 6 and 7
correspond to video accord-
ing to SMPTE 425 level A.
Switch positions 8 and 9
correspond to video accord-
ing to SMPTE 425 level B.
7 1080p, 50
8 2 × 1080i, 59.94 or 60
1 1080i, 50
1080p, 25
1080psf, 25 9 2 × 1080i, 50
A 720p, 29.97 or 30
B 720p, 25
2 525i, 59.94 C 720p, 23.98 or 24
3 625i, 50 D 1080p, 23.98 or 24,
1080psf, 23.98 or 24
4 720p, 59.94 or 60
5 720p, 50 E reserved
F reserved