Grass Valley CR Series v.3.2 - Manual (Page 123)

111
CR Series
User’s Guide
1 Press the level buttons on a panel to select the levels for the take. Be aware of the level selec-
tion exceptions, listed under Exceptions above. The buttons for selected levels are high-tally.
2 Press ‘Destination Mode’.
3 Select a destination.
4 Press ‘Source Mode’.
5 Select a source.
The take is complete. A routing switch occurs on each level you selected at the remote panel
module.
Locks
Performing locks in a network is almost the same as performing locks for a stand-alone CR
Series. However, please note:
• Pressing ‘Panel Lock’ locks that panel and no other.
• A destination lock locks a destination on all selected levels. The lock state of a destination is
not changed on unselected levels.
If all the selected levels of a destination are locked, the destination button is red. If some of
the selected levels of a destination are unlocked, the destination button is amber.
• A destination locked at one control panel cannot be unlocked at another control panel.
 Be sure to unlock any locks before removing a panel from a network!
As previously stated, two of the function buttons are locks and four are level buttons. Two others
are destination mode and source mode.
This illustration shows a system that has 3 levels (1–3), two of which are selected. Buttons for
selected levels are high-tally. The button for (non-existent) level 4 is dark.
Panel Lock
Pressing ‘Panel Lock’ disables the control panel on which you press ‘Panel Lock’. Only the ‘Panel
Lock’ button remains enabled. Pressing it again re-enables the control panel.
PNL
LOCK
DST
LOCK
DST
MODE
SRC
MODE
LVL
4
LVL
3
LVL
2
LVL
1
Level selection buttons
Panel Lock Destination Lock
64
48
32
16
PL DL