Grass Valley CR Series v.3.2 - Manual (Page 120)

108
Operating CR6400 Routers
Stand-Alone CR6400 Router
3 The take is complete.
The panel remains in source mode until you again press ‘Destination Mode’. If you forget to
which destination you made the route, the destination will be high-tally when you press
‘Destination Mode’.
 If a destination is locked, it will be low-tally red. If you press its button, it will go high-tally
red. The panel remains in destination mode. You cannot perform a take for a destination that
is locked. See
Locks .
Locks
The CP6464 has 12 function buttons. Two of the function buttons are locks:
Panel Lock
Pressing ‘Panel Lock’ disables the control panel. Only the Panel Lock button remains enabled.
Pressing it again re-enables the control panel.
When the control panel is locked, the lock button is bright red and the state of the entire control
panel is protected. Changes from the control panel are disabled. The panel lock button is low
tally green when the control panel is not locked.
Destination Lock
Destination lock prevents selecting another source for the currently selected destination. To
lock a destination,
1 Press the ‘Destination Mode’ button.
2 press the desired selection button.
3 Press ‘Destination Lock’.
PNL
LOCK
DST
LOCK
DST
MODE
SRC
MODE
Panel Lock Destination Lock
64
48
32
16
PL DL