Grass Valley 1200 Operation Manual - Manual (Page 46)

2-28
Section 2— Startup
Figure 2-16. GPI Outputs Menu
Tally Menu
The Tally menu (Figure 2-17) displays a table listing the 16
physical signal inputs, indicating those that are high-tallied by
highlighting them.
The AUX TALLY BACK (Aux Bus Tally Back) ON/OFF selection,
when set to ON , allows use of a GPI to tally Aux Bus 1 whenever
the effects send fill crosspoint is tallied and Aux Bus 2 whenever
the effects send source crosspoint is tallied. This provides tally
back for an external DPM without requiring a tally back input
from the DPM. To use this feature, it must be enabled in the Tally
menu and assigned as an event to a GPI input in the GPI Inputs
menu.
The TALLY TEST selection allows you to test the tally output
relays. To test all of the tally outputs, set the [TALLY TEST] soft
button to the ON position; this cycles each output on for about
1/2 second. When finished testing, set the button to OFF .
TALLY MENU
AUX TALLY
BACK
TALLY
TEST
PHYSICAL
INPUT SIGNAL NAME
BLACK BLACK
Exit
J1 VTR 1
J4 VTR 2
J6 R-VTR
J2 CHAR GEN V
J3 CHAR GEN K
J8 DPM-700 VIDEO
ON
OFF
J7 DPM-700 KEY
J9
J8
J11
J12
MATTE
J16 BARS
CAMERA 1
CAMERA 2
PAINTBOX
MATTE
STILL STORE
PHYSICAL
INPUT SIGNAL NAME
ON
OFF