Grass Valley 1200 Operation Manual - Manual (Page 130)

3-84
Section 3 — Controls & Menus
Save Switcher Configuration to Disk
The [SAVE CONFIG] function allows you to save the current
switcher configuration into a file.
A configuration save includes all the parameters you have set
under the [Config] menu in addition to the status of the External
Interface buttons located below the menu screen, the clip mode
settings of the KEYER menu functions, the Aux TallyBack and
Aux re-entry status, and the Effects Send Return fill/source
crosspoints.
NOTE: A configuration file will be saved with the extension suffix.
CFG after the base name (REGISTER). The base name will be the default
file name currently chosen on the display unless you change it by
pushing [SET NAME] and enter a new file name. This is important to
note because if you have saved a previous configuration under one file
name and save a new configuration to that same file name, the old file
will be overwritten with no warning message.