Grass Valley 1200 Operation Manual - Manual (Page 167)

4-5
Transitions
6. To do the transition, move the lever arm to the other limit.
The Preset bus scene will immediately wipe on air as the
Program bus scene wipes off, and the Program and Preset bus
crosspoint selections will flip-flop (swap) at the end of the
transition.
As an alternative to using the lever arm, you can press
[Auto
Trans] to do an automatic transition. To pause an auto
transition in progress, press [Auto Trans] again. To resume
the transition, press it a third time. You can also start an auto
transition and finish with the lever arm or vice versa.
Learning User Wipes
If you develop a wipe setup that you like and you want to save it
for future use, you can do so using the User 1-4 buttons:
1. Press [Learn User Wipe] , followed by one of the four User
buttons, such as [User 1] . The current wipe setup will be
stored in the User button you selected.
2. To recall a stored user wipe, simply press the appropriate
User button. The wipe system will immediately recall the
wipe setup previously stored in that User register.