Grass Valley 1200 Operation Manual - Manual (Page 134)

3-88
Section 3 — Controls & Menus
Disk Load Menu
Press the [LOAD>] button to display the Disk Load menu shown in
Figure 3-45. This menu allows you to load E-MEM registers,
banks of registers, and configuration files (saved settings from the
Configuration menus) from the floppy disk into the switcher.
Disk Load Menu Functions:
(FILE SELECT) —Scrolls through the list of files and directories.
[LIST DIR] —Lists the contents of the current directory. A directory
listing occurs automatically when you enter the menu or change
directories. The main purpose of this soft button is to update the
directory after you change disks.
[CHANGE DIR] —Allows you to move to another directory. To do so,
select the directory using (FILE SELECT) and then push the
[CHANGE DIR]
soft button.
[MARK FILE] —Marks a file for loading.
[LOAD MKD REGS] —Loads marked E-MEM register files from the
disk into the switcher’s E-MEM registers.
[LOAD ALL] —Loads all E-MEM registers files from the disk into the
switcher’s E-MEM registers.
[LOAD MKD CFG] —Loads the marked configuration file from the
disk to the switcher configuration menus.