Grass Valley 1200 Operation Manual - Manual (Page 20)

2-2
Section 2— Startup
System Startup or Restart
Startup
1. Set the 0/1 power switch inside the front cover of the switcher
frame to the 1 (on) position.
2. Set the 0/1 power switch inside the switcher control panel to
the 1 (on) position.
This applies power to the entire system, which will boot up and
become operational in a few seconds. To power down the system
at any time, just switch both power switches to 0 (off).
Restart
If the system becomes confused or locks up, you can restart it as
explained below. The effect you were working on will be lost, but
E-MEM contents and configuration files will remain intact.
1. Press the [Misc] menu button in the upper left corner of the
control panel. Then press the [CLR WORK BUFFER] soft
button in the Miscellaneous Menu to clear the panel.
2. If clearing the panel didn’t help, press the RESET switch on
the Control module (064911) inside the switcher frame.
3. Finally, if neither of the above steps resolves the problem, turn
the frame and panel power switches off and on again.
LampSaver Panel Sleep Mode
Note that the switcher includes a “sleep” mode called LampSaver,
which is intended to extend pushbutton lamp life-span. When the
switcher is idle for an extended period (adjustable) all button
lamps turn off. To wake up the switcher, press any button or turn
any knob. For details about the LampSaver mode, see the
description of the Miscellaneous menu in Section 3.