Grass Valley 1200 Operation Manual - Manual (Page 179)

4-17
Using E-MEM Effects Memory
Using E-MEM Effects Memory
The switcher’s E-MEM ® Effects Memory System includes 20
internal storage registers that you can use to save (learn) switcher
panel setups. You can then recall the saved setups at a later time.
The memory containing stored setups is protected against power
outages, so if power to the switcher is lost, the contents of the
E-MEM registers will remain intact.
Learning an Effect
1. Select the [Learn] pushbutton so that it lights.
2. Select [Bank] and then [0 or 1] . This selects one of the two
banks of ten E-MEM storage registers. (This step is optional if
the bank that you want is already selected.)
3. Select one of the ten [register] pushbuttons [0-9] . The button
will light and the current panel setup will be learned for later
recall. After the learn, the
[Learn] button lamp turns off.
Recalling an Effect
1. Turn off the [Learn] button if it is lit.
2. Select [Bank] and [0 or 1] . (This step is optional if the bank
that you want is already selected.)
3. Select the [register] pushbutton ( [0-9] ) containing the
previously stored panel setup. The panel setup stored in the
register will immediately be recalled.
NOTE: The E-MEM system learns and recalls the switcher controls
but does not cue the video and key sources serving as inputs to the
switcher. When you recall an effect, you may need to cue your sources to
exactly duplicate the picture that existed when the effect was learned.