Grass Valley 1200 Operation Manual - Manual (Page 35)

2-17
System Setup: Using the Configuration Menus
2. Enter a Signal Name by pressing the [CLEAR NAME] soft
button, typing a name on the keyboard, and pressing the
[ENTER NAME] . soft button.
3. Using the [BITS] soft button, identify the input as either an 8
or 10 bit signal.
4. Using the [TYPE SELECT] soft button, identify the input
type: DEPTH (depth key signal from a digital picture
manipulator), KEY , SHAPED (video shaped by a key), or
VIDEO (unshaped).
5. Assign the Effects Return Flag to a video and a key source by
highlighting them and pressing
[EFX RTN FLAG] . This
identifies that video/key input pair as the Effects Send signals
returning from a Digital Picture Manipulator. When Effects
Send is on, the switcher will automatically select these inputs.
6. Assign an Auto Select key input to a video fill input using the
(AUTO SEL KEY SRC) soft knob. Auto Select provides
automatic selection of the associated key input when you
select the fill input on the Key crosspoint bus.
DEFINE INPUTS MENU
10
ENTER
NAME BITS
TYPE
SELECT
EFX RTN
FLAG
8
4:4:4 CK
SOURCES >
XPT DISP
LEGENDS >
PHYSICAL INPUT
= J2
AUTO SEL
KEY SRC
= J3
PHYSICAL
INPUT SIGNAL NAME BITS TYPE
AUTO
SEL
EFFECTS
RETURN
J1 VTR 1 10 VIDEO
J2
J3
J4
J5 CHAR GEN VID 10 SHAPED J3
CHAR GEN KEY 10 KEY
VTR 2 10 VIDEO
8
VTR 3 8 VIDEO
DEPTH
KEY
SHAPED
VIDEO
Exit
CLEAR
NAME
J6 R-VTR VIDEO
J7
J8
DPM-700 KEY 10 KEY
DPM-700 VIDEO 10 J7
KEY
VIDEO SHAPED