Grass Valley 1200 Operation Manual - Manual (Page 42)

2-24
Section 2— Startup
Port Menu
The Port Configuration menu (Figure 2-14) is displayed by
pressing the
[Config] button on the main subpanel and then the
[PORTS>] soft button.
1. Use the (PORT) soft knob to highlight the port you wish to
configure. (Ports are listed in the left-most display column.)
2. Use the (PROTOCOL) soft knob to select the protocol for the
port. Protocol settings for typical equipment are listed below:
Panel Port —Already set for 1200 PNL protocol (RS-422,
address 30H, 38400 baud, 8 bits, 1 stop bit, odd parity).
Cannot be changed.
Terminal (TTY) Port —Use TERMINAL protocol (RS-232,
9600 baud, 8 bits, 1 stop bit, no parity).
Modem Port —Use MODEM protocol (RS-232, 2400 baud, 8
bits, 1 stop bit, no parity).
DPM-100/700 Port —Use DPM protocol (RS-422, address
30H, 38.4 K baud, 8 bits, 1 stop bit, odd parity).
Editor Port —Use Grass Valley 1200 (address 30H).
Communication is RS-422, 38.4K baud, 8 bits, 1 stop bit, odd
parity. You may also use
110 or 200 switcher protocol if your
editor does not have a 1200 interface, but functionality will be
reduced.
Aux Satellite Panel Port —Use 200 or 1200 AUX protocol
(RS-422, 9600 baud, 8 bits, 1 stop bit, no parity). Any available
port may be used for the Aux Satellite Panel.