Grass Valley Jupiter v.1.0 - Manual (Page 82)

82 Jupiter L-S Series Control Panels Installation and Operating Manual
Section 5 — L-S Series Panel Operation
2. Press the LEVEL button so it is illuminated. All levels will be deselected
and their soft buttons will turn off.
3. Toggle ON the soft button corresponding to the level(s) to be switched.
To move beyond the first 14 levels, use the
Up/Down arrow buttons.
4. Select a source using one of the methods described under Selecting a
Source (Single Destination Mode) on page 79 .
5. Press Take . The source will switch only on the selected levels, while the
non-selected levels will remain at the previously selected source.
6. The level windows will indicate status of the first 14 levels of the
switcher.
• If Sticky Levels is off, after the Take all levels will automatically be
deselected (their buttons will turn off). If Sticky Levels is on, only
the levels involved in the last Take will remain selected.
Sticky Levels Mode
If Sticky Levels mode is ON, the level(s) involved in a breakaway Take
remain selected for subsequent Takes. To turn on Sticky Levels mode:
1. Press Menu . The display windows will display various modes.
2. Press the Panel Config? soft button. The Sticky Level menu will be
displayed with its current status (ON or OFF).
3. Press Take to toggle the state ON or OFF)
LD16 Multiple Destination Mode
Multiple destination mode, sometimes referred to as “multi-bus” mode, is
in effect when various destinations, in yellow, appear in the D1-D16 win-
dows; and level names (“video” etc.) do not appear.
This mode displays the top level (e.g., video) status for 16 destinations.
Additional pages of destinations each can be accessed using the
Up/Down
arrow buttons. Multiple destinations can be selected for single-Take
switching.
Entering Multiple Destination Mode
1. Press Menu . The display windows will display various modes.