Breakaway source status, Sticky levels mode, Executing a sequence (salvo) – Grass Valley Jupiter v.1.0 User Manual
Page 65: Direct execution
Jupiter L-S Series Control Panels Installation and Operating Manual
65
L32/L64 Control Panels
Breakaway Source Status
To identify which sources are currently switched to the levels of a destina-
tion:
1.
Confirm the destination you want to examine appears in yellow in the
Destination window.
2.
Press just the
Level
button.
3.
Use the
Up/Down
arrow buttons to view the status of each level. The
name of the current source will be displayed in green along with the
name of the level. If that source button is assigned on the panel it will
illuminate.
4.
Press the
Level
button again to turn off the mode.
Sticky Levels Mode
You can turn on Sticky Levels mode to keep active only the last selected
levels after a breakaway take.
1.
Press the
Menu
button, use the
Up/Down
arrow buttons to scroll to
Panel
Config?
and press
Take.
2.
The Sticky Level menu will be displayed with its current status (ON or
OFF).
3.
Press
Take
to toggle the state ON or OFF)
4.
Press
Clear
to escape configuration mode.
Executing a Sequence (Salvo)
After a sequence is created and downloaded (see
) it can be executed as follows:
Direct Execution
In order to directly execute a sequence, that must be assigned to a panel
button (see
).
1.
Press the assigned Sequence button for the desired sequence.
All the destinations in the sequence will immediately be switched to their
designated sources.