Grass Valley Jupiter v.1.0 User Manual
Page 72
72
Jupiter L-S Series Control Panels Installation and Operating Manual
Section 5 — L-S Series Panel Operation
Level Select mode on the LD4 panel is set via the menu:
1.
Press the
Menu
button. The windows will display various configuration
modes. Press the
Up/Down
arrow buttons to display the
Level Select
window (D3). It will report its current setting, either
ALL ON
or
ALL OFF.
2.
Press the soft button for
Level Select
. The mode will toggle to the other
state and the panel will exit Menu mode.
Breakaways can be disabled on the CP Level Set table by setting the Break
Flag for each level to `N.'
Deselect Levels Method
1.
Confirm the desired active destination is shown in yellow in the
Destination window and Level Select mode is
ALL_ON
.
2.
Press the soft buttons for the levels you do NOT want to switch so the
buttons are turned off. To move beyond the first 4 levels, use the
Up/Down
arrow buttons.
3.
Select a source, using one of the methods described under
Source (Single Destination Mode) on page 70
. The selected (i.e., preset)
source will appear in cyan.
•
If the level indicator is blank, the source may not exist on that level
(e.g., audio from a camera).
4.
Press
Take
. The source will switch only on the selected levels to the
controlled destination, while the non-selected levels remain at the
previously selected source. The level windows will indicate the status
of the first 4 levels.
•
If Sticky Levels is off, after the Take all levels will automatically be rese-
lected (their soft buttons will illuminate). If Sticky Levels is on, only the
levels involved in the last Take will remain selected.
Select Levels Method
This method is the reverse of the above procedure.
1.
Confirm the desired active destination is shown in yellow in the
Destination window and Level Select mode is
ALL_OFF
.
2.
Toggle ON the soft button(s) corresponding to the level(s) to be
switched. To move beyond the first 4 levels, use the
Up/Down
arrow
buttons.
3.
Select a source using one of the methods described under
Source (Single Destination Mode) on page 70
.
4.
Press
Take
. The source will switch only on the selected levels, while the
non-selected levels will remain at the previously selected source.