Grass Valley Jupiter v.1.0 - Manual (Page 61)

Jupiter L-S Series Control Panels Installation and Operating Manual 61
L32/L64 Control Panels
Menu Selection Method
1. Clear the panel ( Level , Menu , and Preset buttons OFF).
2. Press the Menu button. The window will display configuration modes.
3. If necessary, use the Up/Down arrow buttons to scroll to Select Destination?
mode.
4. Press Take . Destination names will appear in the Status (L32) or Preset
(L64) window.
5. Use the Up/Down arrow buttons to scroll to the desired destination.
6. Press Take . The Destination window will display the name of the
destination now being controlled.
You will now be able to select a different source for that destination.
Selecting a Source
Note If a destination has been Protected or Locked by another panel, the Protect/
Lock button will illuminate steady amber (Protect) or red (Lock) and the des-
tination will not be able to be switched. To continue, the destination must be
unprotected or unlocked by the panel that set the protect or lock (the name
of that other panel will be displayed in the menu).
Direct Selection Method
Buttons configured for sources illuminate in green.
1. Clear the panel ( Level , Menu , and Preset buttons OFF)
2. Press the low green button for the desired source. The source will be
switched to that destination, the button will illuminate in bright green,
and the name for the source will be shown in green in the Status
window.
Direct Selection with Preset
Preset allows you to confirm the identify of the source before it is switched
to the destination.
1. Press Preset so it is illuminated.
2. Press the low green button for the desired source. The source will NOT
be taken to that destination. Instead, the
Take button will illuminate
along with the source button just pressed, and the name of the source
will be displayed in blue in the Status (L32) or Preset (L64) window.
Different sources can be selected until the correct one is found.