Grass Valley Jupiter v.1.0 - Manual (Page 76)

76 Jupiter L-S Series Control Panels Installation and Operating Manual
Section 5 — L-S Series Panel Operation
2. Press the Protect/Lock button once (protected destination) or twice
(locked destination). The Take button will illuminate.
3. Press Take . The protect or lock state will be cleared.
Source Swap Mode (LD4 Panel)
If Source Swap mode is ON, the display windows will preset to the previ-
ously-selected source, in cyan, after each Take. This permits flip-flop
switching on the LD4 panel using just the
Take button.
1. Press Menu . The display windows will display various modes.
2. Use the Up/Down arrow buttons to display Panel Config? in the D4 window
and press its soft button.
3. The Source Swap menu will be displayed in the D2 window with its
current status (ON or OFF).
4. Press Take to toggle the state ON or OFF.
The panel will exit Menu mode and operate with the new state.
Overrides (LD4 Panel)
Overrides can be used for a quick or emergency switch to an often-used
source and level combination. For example, the black burst generator could
be defined as the first “override” source for a particular control panel, cor-
responding to the first override soft key position. Override names can be
customized if desired. Each override can be configured to switch any
desired combination of router levels. The order that the overrides are listed
on the CP Override set table will be the order in which they appear on the
panel.
To Execute an Override
1. Select the desired destination.
2. Press Menu , use the Up/Down arrow buttons to display Select Override in
the D2 window and press its soft button.
3. The display windows will indicate available overrides. To scroll to
additional override groups, use the
Up/Down arrow buttons.
4. Press the soft button next to the desired override.
5. To execute the override switch, press Take . The sources on the levels
specified in the override will be switched to the destination.