Grass Valley Jupiter v.1.0 - Manual (Page 66)

66 Jupiter L-S Series Control Panels Installation and Operating Manual
Section 5 — L-S Series Panel Operation
Direct Execution with Preset
Preset allows you to select a sequence assigned to buttons and identify it by
name before executing it.
1. Press Preset so it is illuminated.
2. Press the low amber button for the desired sequence. The sequence will
NOT execute. Instead, the
Take button will illuminate and the name of
the sequence will be displayed on the menu. Different sequences can be
selected with their assigned buttons until the correct one is found.
3. Press Take . That sequence will execute and all the sources will be
switched to their destinations.
4. To exit Preset mode, press the Preset button so it is turned off.
Menu Execution
1. Press the Menu button. The Status/Destination window will display
configuration modes.
2. Use the Up/Down arrow buttons to scroll to Select Sequence? mode.
3. Press Take . Sequence names will appear in the Status window.
4. Use the Up/Down arrow buttons to scroll to the desired sequence.
5. Press Take . All the destinations in the sequence will be switched to their
designated sources.
Source Swap Mode
Turning on Source Swap mode allows rapid permits flip-flop switching
between two sources. The last selected source is retained (displayed in
Cyan), and pressing the Take button returns the destination to that pre-
vious source.
1. Press the Menu button, use the Up/Down arrow buttons to scroll to Panel
Config? and press Take.
2. Scroll to the Source Swap menu, which displays its current status (ON
or OFF).
3. Press Take to toggle the state ON or OFF and exit Menu mode.