Grass Valley Jupiter v.1.0 - Manual (Page 55)

Jupiter L-S Series Control Panels Installation and Operating Manual 55
Section
5
L-S Series Panel Operation
Introduction
This section assumes panels have been properly installed and configured
for operation at your facility. Buttons are configured to control sources and
destinations using the Jupiter CP Input and Output sets, Levels are deter-
mined with CP Level sets, and these sets are assigned to the panel using the
MPK Devices table (see
Section 4-Jupiter System Configuration ).
Section Contents
L32/64 Control Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 59
LD4 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 69
LD16 Control Panel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 78
S25/S50 Control Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 87
S100 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 90
SXY Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 93
Color Bitmap Displays
Three different types of L-S panel color displays exist. Different panel types
are equipped with different display types and numbers. The S25 and S50
panels do not have color bitmap displays.
Typical display information is indicated below. Different information is dis-
played in some modes, however. For example, pressing the
Menu button
brings up screens allowing menu navigation and setting selections.
Destination/Status
Typically reports the names of the currently controlled destination and the
source currently routed to that destination. The status display may also
show the source or destination selected for the next action.