Grass Valley Jupiter v.1.0 - Manual (Page 53)

Jupiter L-S Series Control Panels Installation and Operating Manual 53
Compiling
“SETUP2” will switch the cameras to VTRs 1 through 3. Each sequence can
include up to 25 events (table rows).
There is no specific limit to the number of sequences, but due to memory
restrictions a limit of 16 is recommended (e.g., “SETUP1” through
“SETUP16.”
The sequence set must be assigned to the panel on the Jupiter MPK Devices
table.
For additional information regarding Jupiter sequences and assigning
them to control panels, refer to the Jupiter CM-4000 Installation and Oper-
ating Manual.
Note Sequences are executed in slightly different ways, depending on the buttons
available on each panel type. Refer to the specific instructions for each panel.
Compiling
Before the panel(s) can be operated, the edited Jupiter set must be compiled
and the appropriate configuration set made active using the Control
Center. For more information, refer to the Jupiter CM-4000 Installation and
Operation Manual.
Following this step, the CM-4000/AccuSwitch control system should start
communicating with the panel(s); i.e., the panel(s) will indicate some form
of router status.