Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual
Page 79
3-16
z
Specify that a username sent to the RADIUS server carries the domain name. The username of
the user is dot1x@bbb.
z
After the host passes authentication, the authentication server assigns the host to VLAN 4.
z
The host registers a monthly service charging 120 dollars for up to 120 hours per month.
Figure 3-16 Configure AAA for 802.1X users by a RADIUS server
Configuration procedure
z
Configure the interfaces and VLANs as per
. Make sure that the host can get a new IP
address manually or automatically and can access resources in the authorized VLAN after
passing authentication.
z
This example assumes that the RADIUS server runs iMC PLAT 3.20-R2606 and iMC UAM
3.60-E6206.
1) Configure the RADIUS server
# Add an access device.
Log in to the iMC management platform, select the Service tab, and select Access Service > Access
Device from the navigation tree to enter the Access Device List page. Then, click Add to enter the
Add Access Device page and perform the following configurations:
z
Set the shared keys for authentication and accounting packets to expert
z
Specify the ports for authentication and accounting as 1812 and 1813 respectively
z
Select LAN Access Service as the service type
z
Select H3C as the access device type
z
Select the access device from the device list or manually add the device whose IP address is
10.1.1.2
z
Adopt the default settings for other parameters and click OK to finish the operation.