Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual
Page 71
3-8
z
Set the shared keys for authentication and authorization packets exchanged between the switch
and the RADIUS server as expert and specify the ports for authentication/authorization and
accounting as 1812 and 1813 respectively.
z
Specify that a username sent to the RADIUS server carries the domain name.
z
The portal user registers a monthly service charging 120 dollars for up to 120 hours per month.
Figure 3-6 AAA for portal users by a RADIUS server
Internet
Portal user
192.168.1.58/24
Gateway : 192.168.1.70/24
RADIUS server / Portal server
10.1.1.1/24
Vlan-int2
192.168.1.70/24
Vlan-int3
10.1.1.2/24
Switch
Configuration procedure
z
Configure IP addresses for the devices as per
and ensure that devices can reach each
other.
z
The following describes how to configure the portal server and RADIUS server on the iMC. This
example assumes that the RADIUS server runs iMC PLAT 3.20-R2606 and iMC UAM
3.60-E6206.
1) Configure the RADIUS server
# Add an access device.
Log in to the iMC management platform, select the Service tab, and select Access Service > Access
Device from the navigation tree to enter the Access Device List page. Then, click Add to enter the
Add Access Device page and perform the following configurations:
z
Set the shared keys for authentication and accounting packets to expert
z
Specify the ports for authentication and accounting as 1812 and 1813 respectively
z
Select LAN Access Service as the service type
z
Select H3C as the access device type
z
Select the access device from the device list or manually add the device whose IP address is
10.1.1.2
z
Adopt the default settings for other parameters and click OK to finish the operation.