H3C Technologies H3C S7500E Series Switches - Manual (Page 210)

11-6
To do… Use the command… Remarks
Enter system view system-view —
Enable the SSH server function ssh server enable
Required
Disabled by default
Configuring the User Interfaces for SSH Clients
An SSH client accesses the device through a VTY user interface. Therefore, you need to configure the
user interfaces for SSH clients to allow SSH login. Note that the configuration takes effect only for
clients logging in after the configuration.
Follow these steps to configure the protocols for the current user interface to support:
To do… Use the command… Remarks
Enter system view system-view —
Enter user interface view of one or
more user interfaces
user-interface vty number
[ ending-number ]
—
Set the login authentication mode
to scheme
authentication-mode scheme
Required
By default, the authentication
mode is password.
Configure the user interface(s) to
support SSH login
protocol inbound { all | ssh }
Optional
All protocols are supported by
default.
z For more information about the authentication-mode and protocol inbound commands, see
Logging In to the Switch Commands in the Fundamentals Command Reference.
z If you configure a user interface to support SSH, be sure to configure the corresponding
authentication mode with the authentication-mode scheme command.
z For a user interface configured to support SSH, you cannot change the authentication mode. To
change the authentication mode, undo the SSH support configuration first.
Configuring a Client Public Key