H3C Technologies H3C S7500E Series Switches User Manual
Page 72
3-9
The IP address of the access device specified above must be the same as the source IP address of
the RADIUS packets sent from the device, which is the IP address of the outbound interface by default,
or otherwise the IP address specified with the nas-ip or radius nas-ip command.
Figure 3-7 Add an access device
# Add a charging plan.
Select the Service tab, and select Charging Service > Charging Plans from the navigation tree to
enter the charging plan configuration page. Then, click Add to enter the Add Charging Plan page
and perform the following configurations:
z
Add a plan named UserAcct
z
Select Flat rate as the charging template
z
In the Basic Plan Settings field, configure the fixed fee as 120 dollars per month
z
In the Service Usage Limit field, set the Usage Threshold to 120 hours, allowing the user to
access the Internet for up to 120 hours per month
z
Adopt the default settings for other parameters and click OK to finish the operation.