H3C Technologies H3C S7500E Series Switches - Manual (Page 239)

12-9
-rwxrwxrwx 1 noone nogroup 225 Aug 24 08:01 pubkey2
-rwxrwxrwx 1 noone nogroup 283 Aug 24 07:39 pubkey
drwxrwxrwx 1 noone nogroup 0 Sep 01 06:22 new
-rwxrwxrwx 1 noone nogroup 225 Sep 01 06:55 pub
drwxrwxrwx 1 noone nogroup 0 Sep 02 06:33 new2
# Download the pubkey2 file from the server and save it as local file public.
sftp-client> get pubkey2 public
Remote file:/pubkey2 ---> Local file: public
Downloading file successfully ended
# Upload the local file pu to the server, save it as puk, and check if the file has been uploaded
successfully.
sftp-client> put pu puk
Local file:pu ---> Remote file: /puk
Uploading file successfully ended
sftp-client> dir
-rwxrwxrwx 1 noone nogroup 1759 Aug 23 06:52 config.cfg
-rwxrwxrwx 1 noone nogroup 225 Aug 24 08:01 pubkey2
-rwxrwxrwx 1 noone nogroup 283 Aug 24 07:39 pubkey
drwxrwxrwx 1 noone nogroup 0 Sep 01 06:22 new
drwxrwxrwx 1 noone nogroup 0 Sep 02 06:33 new2
-rwxrwxrwx 1 noone nogroup 283 Sep 02 06:35 pub
-rwxrwxrwx 1 noone nogroup 283 Sep 02 06:36 puk
sftp-client>
# Terminate the connection to the remote SFTP server.
sftp-client> quit
Bye
Connection closed.
SFTP Server Configuration Example
Network requirements
As shown in Figure 12-2 , an SSH connection is established between the host and the switch. The host,
an SFTP client, logs into the switch for file management and file transfer. An SSH user uses password
authentication with the username being client002 and the password being aabbcc. The username
and password are saved on the switch.
Figure 12-2 Network diagram for SFTP server configuration
SFTP client SFTP server
Host Switch
192.168.1.56/24
Vlan-int1
192.168.1.45/24
Configuration procedure
1) Configure the SFTP server
# Generate the RSA key pairs.
system-view
[Switch] public-key local create rsa