H3C Technologies H3C S7500E Series Switches - Manual (Page 46)

2-17
does not require the RADIUS client to resolve the attribute. Currently, some RADIUS servers use the
class attribute to deliver the assigned committed access rate (CAR) parameters. To support such
applications, configure the RADIUS client to interpret the class attribute as the CAR parameters.
Follow these steps to configure the RADIUS client to interpret the class attribute as the CAR
parameters:
To do… Use the command… Remarks
Enter system view system-view —
Enter RADIUS scheme view
radius scheme
radius-scheme-name
—
Specify to interpret the class
attribute as the CAR parameters
attribute 25 car
Required
Be default, RADIUS attribute 25 is not
interpreted as CAR parameters.
z Whether to configure this command depends on the implementation of the device and RADIUS
server.
z Currently, the S7500E series Ethernet switches do not support assigning CAR parameters
through the class attribute.
Enabling the RADIUS trap function
If a NAS sends an accounting or authentication request to the RADIUS server but gets no response,
the NAS retransmits the request. With the RADIUS trap function enabled, when the NAS transmits the
request for half of the specified maximum number of transmission attempts, it sends a trap message.
Follow these steps to enable the RADIUS trap function:
To do… Use the command… Remarks
Enter system view system-view —
Enable the RADIUS trap
function
radius trap
{ accounting-server-down |
authentication-server-down }
Required
Disabled by default
Enabling the listening port of the RADIUS client
Follow these steps to enable the listening port of the RADIUS client:
To do… Use the command… Remarks
Enter system view system-view —