H3C Technologies H3C S7500E Series Switches User Manual
Page 68
3-5
This example assumes that the RADIUS server runs iMC PLAT 3.20-R2606 and iMC UAM
3.60-E6206.
# Add an access device.
Log in to the iMC management platform, select the Service tab, and select Access Service > Service
Configuration from the navigation tree to enter the Service Configuration page. Then, click Add to
enter the Add Access Device window and perform the following configurations:
z
Set both the shared keys for authentication and accounting packets to expert
z
Specify the ports for authentication and accounting as 1812 and 1813 respectively
z
Select Device Management Service as the service type
z
Select H3C as the access device type
z
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2
z
Click OK to finish the operation
The IP address of the access device specified above must be the same as the source IP address of
the RADIUS packets sent from the device, which is the IP address of the outbound interface by default,
or otherwise the IP address specified with the nas-ip or radius nas-ip command.
Figure 3-4 Add an access device
# Add a user for device management