H3C Technologies H3C S7500E Series Switches - Manual (Page 76)

3-13
z Type the key, which is portal, the same as that configured on the switch.
z Set whether to enable IP address reallocation. Direct portal authentication is used in this example,
and therefore select No from the Reallocate IP drop-down list.
z Click OK to finish the operation.
Figure 3-13 Add a portal device
# Associate the portal device with the IP address group.
As shown in Figure 3-14 , in the device list on the portal device configuration page, click the icon in the
Port Group Information Management column of device NAS to enter the port group configuration
page.
Figure 3-14 Device list
On the port group configuration page, click Add to enter the page for adding a port group, as shown in
Figure 3-15 . Perform the following configurations:
z Type the port group name.
z Select the configured IP address group. Note that the IP address used by the user to access the
network must be within this IP address group.
z Use the default settings for other parameters and click OK to finish the operation.