Ensemble Designs 9430 Flexible Matrix Router for 3G / HD / SD / ASI - Manual (Page 39)

www.ensembledesigns.com Page 39
Avenue 9430 Flexible Matrix Router Installation, Configuration and Operations Guide
Chapter 4: Configuration
In this Chapter
This chapter covers the following topics:
• The Router’s Network Environment
• Avenue Touch Screen and Avenue PC Controls
• Initially Connecting to the Router
• Assigning the Router a New IP Address and Subnet Mask
• Establishing Initial Control Point and Profile for Administrator Functions
• Configuring the Router’s Ports
• Creating and Editing Profiles
• Establishing Control Points and Access Authentication
• Setting Up Timing and Genlock
• Configuring Internal Test Signal Generators
• Switch Point Identification
• Working with the Clean Switch Option
The Router's Network Environment
The 9430 Router Module and the Router Control Panels (5830) communicate over a 100 Mb Ethernet
LAN (Local Area Network). In this section, we cover the essential factors for configuring the Router in a
typical networking environment. Your own networking environment may differ. While we recommend
certain practices, you must nevertheless configure the network parameters in each of these devices in
accordance with your network.
Avenue Touch Screen and Avenue PC Controls
While the primary method for controlling the Router is through the web browser interface discussed
in Chapter 5: Operations and Step-by-Step Procedures on page 87, the Avenue Touch Screen or
Avenue PC Controls are used for initially assigning the Router and optional Control Panel new IP
Addresses and Subnet Masks as needed.
If you do not use Avenue Touch Screen or Avenue PC Controls, see Method Two: For Customers Not
Using Avenue Touch Screen or Avenue PC on page 42.