Ensemble Designs 9430 Flexible Matrix Router for 3G / HD / SD / ASI - Manual (Page 123)

www.ensembledesigns.com Page 123
Avenue 9430 Flexible Matrix Router Installation, Configuration and Operations Guide
Status Response
Certain commands sent to the 9430 Router require that a Status Response be returned by the router.
This response identifies the source that is currently switched to the destination specified. The response
takes this form:
Syntax: S:,
S: ASCII character ‘S’ (53H) followed by ASCII character ‘:‘
(3AH).
Identifies this as a Status Response.
This is the level.
The 9430 Router will always report this to 0.
Destination number.
No leading zeros will be used.
Any valid ASCII hex digits. (E.g. ‘0’ to ‘9’ or ‘A’ to ‘F’).
, Comma character (2CH).
Separates destination numbers from source numbers.
Source number.
No leading zeros will be used.
Any valid ASCII hex digits. (E.g. ‘0’ to ‘9’ or ‘A’ to ‘F’).
ASCII carriage return character (0DH).
ASCII line feed character (0AH).
Example: In response to a Direct Crosspoint Take command, suppose that the 9430 Router
reports that Source 11 (0BH) is selected on Destination 4. The response would look as
follows. (Note that the router will always report the Level as 0):
Response: In Hex 53 3A 30 34 2C 62 0D 0A
In ASCII S:04,b
Note: After the Status Response is sent, a Prompt Response is sent.
7.3.3 Commands
This section lists the commands supported in the Generic ASCII protocol.
Commands from the original Leitch Pass-Through Protocol that are not listed in this section are not
supported by the 9430 router and will be ignored.