Ensemble Designs 9430 Flexible Matrix Router for 3G / HD / SD / ASI - Manual (Page 35)

www.ensembledesigns.com Page 35
Avenue 9430 Flexible Matrix Router Installation, Configuration and Operations Guide
Button legends can be inserted between the clear
overcap and the white diffuser of the key cap.
Labeling Buttons
The Router Control Panel comes with two button labeling options:
1. Pre-printed key cap inserts, described on this page, and
2. A customizable label template that generates a PDF, described on the next page.
First Method: Key Cap Inserts
The provided key cap inserts give a broad range of terms and numbers printed on clear plastic sheets.
Each individual button legend pops out from its sheet and can be inserted into the Router Control
Panel buttons between the clear overcap and the white diffuser, if desired.
The button legends are designed to be used individually—one per button, or as a combined set—two
on a button. When combining them, one appears higher on the button and the other appears lower.
To Place a Button Legend Inside a Control Panel Button
1. Pull a button off of the Control Panel by simply squeezing and pulling. Each button is held to the
Panel with a pressure fit. A bit of pressure is required.
2. Remove the inner white diffuser part of the button from the clear overcap with a fingernail or a
sharp edged tool. Note the orientation of each button: there are slightly indented slits located on
the top and bottom of both the clear overcap and white diffuser.
3. Place a button legend between the clear overcap and the white diffuser, keeping both parts
aligned top to bottom and noting orientation. Snap the two button pieces back together.
4. Snap the button back in place on the Control Panel with some slight pressure. The button must be
level to the plane of the Panel before it will snap correctly back into place.