Westermo PMI-110-F2G - Manual (Page 77)

Priority: Enter a value between 0 and 240, using multiples of 16. This is the value
that decides which port should be blocked by priority in a LAN.
Link Type: There are 3 types for you select. Auto, P2P and Share.
Some of the rapid state transitions that are possible within RSTP depend upon
whether the port of concern can only be connected to another bridge (i.e. it is
served by a point‐to‐point LAN segment), or if it can be connected to two or
more bridges (i.e. it is served by a shared‐medium LAN segment). This function
allows link status of the link to be manipulated administratively. “Auto” means to
auto select P2P or Share mode. “P2P” means P2P is enabled; the 2 ends work in
full duplex mode. While “Share” is enabled, it means P2P is disabled; the 2 ends
may connect through a share media and work in half duplex mode.
Edge: A port directly connected to the end stations cannot create a bridging loop
in the network. To configure this port as an edge port, set the port to the Enable
state. When the non‐bridge device connects an admin edge port, this port will be
in blocking state and turn to forwarding state in 4 seconds.
Once you finish your configuration, click on Apply to save your settings.
4.5.6 MSTP Information
This page allows you to see the current MSTP information.
Choose the Instance ID first. If the instance is not added, the information remains
blank.
The Root Information shows the setting of the Root switch.
The Port Information shows the port setting and status of the ports within the
instance.
73