Westermo PMI-110-F2G - Manual (Page 57)

Group ID: Display Trunk 1 to Trunk 5 set up in Aggregation Setting.
Type: Static or LACP set up in Aggregation Setting.
Aggregated: When LACP links well, you can see the member ports in aggregated
column.
Individual: When LACP is enabled, member ports of LACP group which are not
connected to correct LACP member ports will be displayed in the Individual
column.
Link Down: When LACP is enabled, member ports of LACP group which are not
linked up will be displayed in the Link Down column.
4.3.5 Command Lines for Port Configuration
Feature Command Line
Port Control
Port Control – State
Switch(config‐if)# shutdown ‐> Disable port state
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Switch(config‐if)# no shutdown ‐> Enable port state
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config‐if)# Port1 Link Change to UP
Port Control – Auto
Negotiation Switch(config)# interface fa1
Switch(config‐if)# auto‐negotiation
Auto‐negotiation of port 1 is enabled!
Port Control – Force
Speed/Duplex Switch(config‐if)# speed 100
Port1 Link Change to DOWN
set the speed mode ok!
Switch(config‐if)# Port1 Link Change to UP
Switch(config‐if)# duplex full
Port1 Link Change to DOWN
set the duplex mode ok!
Switch(config‐if)# Port1 Link Change to UP
53