Westermo PMI-110-F2G - Manual (Page 60)

4.4 Power over Ethernet
Power over Ethernet is the key features of PMI PoE Switch. It is fully compliance
with IEEE 802.3af and IEEE 802.3at that include 1‐event with IEEE 802.1AB LLDP
classification and 2‐event classification mechanisms for PoE MDI. The
PMI‐110‐F2G adapts 8‐Port PoE injectors in port 1 to port 8, each port with the
ability to deliver 30W to compatible IEEE 802.3at standard and provides 120w
power budget for hall system. Therefore, select and install the PoE PD system is
The following commands are included in this section:
4.4.1 PoE Control
4.4.2 PoE Scheduling
4.4.3 PoE Status
4.4.4 Command Line for PoE control
4.4.1 PoE Control
The PoE contrl includes 3 parts‐ PoE System, Port configuration and PD status
detection. The following will iintroduce the function.
PoE System Dialogue
PoE System: enable or disable system’s PoE function.
Budget (W): the power supply maximum output budget. Both power budget of
DC 1 and DC2 will be aggregated.
Voltage (V): the voltage of applied to the power input. Here, we suggest uses
same specification of power supply. If the power supply with different output
voltage, it may casue system draw more current from one power model which
with higher voltage.
Warning Water Level (%): the warning level is for system warning to alerts user
when PoE system drawing power that meet the warning level user defined.
Port Configuration Dialogue
56