Westermo PMI-110-F2G - Manual (Page 23)

3 Preparation for Management
PMI Industrial Managed PoE Switch provides both in‐band and out‐band
configuration methods. You can configure the switch via RS232 console cable if
you don’t attach your admin PC to your network, or if you lose network
connection to your PMI PoE Managed Switch. This is so‐called out‐band
management. It wouldn’t be affected by network performance.
The in‐band management means you can remotely manage the switch via the
network. You can choose Telnet or Web‐based management. You just need to
know the device’s IP address and you can remotely connect to its embedded
HTTP web pages or Telnet console.
Following topics are covered in this chapter:
3.1 Preparation for Serial Console
3.2 Preparation for Web Interface
3.3 Preparation for Telnet console
3.1 Preparation for Serial Console
In the unit package, Westermo attached one RJ‐45 to RS‐232 DB‐9 console
cable. Please attach RS‐232 DB‐9 connector to your PC’s COM port, connect
RJ‐45 connector to the Console port of the PMI PoE Managed Switch. If the
serial cable is lost, please follow the serial console cable PIN assignment to find
one. (Refer to the appendix).
1. Go to Start ‐> Program ‐> Accessories ‐> Communication ‐> Hyper Terminal
2. Give a name to the new console connection.
3. Choose the COM name
4. Select correct serial settings. The serial settings of PMI PoE Managed
Switches are as below:
Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1
5. After connected, you can see Switch login request.
6. Login the switch. The default username is “admin”, password,
“westermo”
.
Switch login: admin
Password:
The switch (version 1.1.5-20100414-11:04:13).
Switch>
19