Westermo PMI-110-F2G - Manual (Page 140)

4.14 Device Front Panel
Device Front Panel commands allows you to see LED status of the switch. You can
see LED and link status of the Power, DO, R.M. and Ports.
Feature LED On LED Blinking LED off
Power Power is on applying Not avaliable No power
Sys System ready System is on progress
firmware upgrade or not
ready
System not ready
R.S. Green on: switch is working as ring
master
Red blinking: Ring failed Switch is working at slave
mode.
Alarm Green on: alarm relay active and
contacts is short.
Not avaliable Green off: relay output
contact is open.
LNK/ACT Port is linked Port is on transmitting Port is link down
1000M The port is linked at 1000Mbps
speed.
Not avaliable Not avaliable
PoE Green on: powering On detecting Power output over current
or cable short
Note: No CLI command for this feature.
136