Westermo PMI-110-F2G - Manual (Page 128)

4.12.2.2 SysLog Configuration
System Log is useful to provide system administrator locally or remotely monitor
switch events history. There are 2 System Log modes provided by PMI Switch,
local mode and remote mode.
Local Mode: In this mode, PMI Switch will print the occurred events selected in
the Event Selection page to System Log table of PMI Switch. You can monitor the
system logs in [Monitor and Diag] / [Event Log] page.
Remote Mode: The remote mode is also known as Server mode in PMI managed
switch series. In this mode, you should assign the IP address of the System Log
server. PMI Switch will send the occurred events selected in Event Selection page
to System Log server you assigned.
Both: Above 2 modes can be enabled at the same time.
Once you finish configuring the settings, click on Apply to apply your
configuration.
Note: When enabling Local or Both modes, you can monitor the system logs in
[Monitor and Diag] / [Event Log] page.
4.12.2.3 SMTP Configuration
PMI Switch supports E‐mail Warning feature. The switch will send the occurred
events to remote E‐mail server. The receiver can then receive notification by
E‐mail. The E‐mail warning is conformed to SMTP standard.
This page allows you to enable E‐mail Alert, assign the SMTP Server IP, Sender
E‐mail, and Receiver E‐mail. If SMTP server requests you to authorize first, you
can also set up the username and password in this page.
124