Westermo PMI-110-F2G - Manual (Page 58)

Port Control – Flow
Control Switch(config‐if)# flowcontrol on
Flowcontrol on for port 1 set ok!
Switch(config‐if)# flowcontrol off
Flowcontrol off for port 1 set ok!
Port Status
Port Status
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Connected
Duplex : Full
Speed : 100
Flow Control :off
Default Port VLAN ID: 1
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Mdix mode is Disable.
Medium mode is Copper.
Note: Administrative Status ‐> Port state of the port. Operating
status ‐> Current status of the port. Duplex ‐> Duplex mode of the
port. Speed ‐> Speed mode of the port. Flow control ‐> Flow Control
status of the port.
Rate Control
Rate Control – Ingress
or Egress
Switch(config‐if)# rate‐limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule
first; then assign the packet type and bandwidth.
Rate Control – Filter
Packet Type
Switch(config‐if)# rate‐limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded‐unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config‐if)# rate‐limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control ‐
Bandwidth
Switch(config‐if)# rate‐limit ingress bandwidth
<0‐100> Limit in magabits per second (0 is no limit)
Switch(config‐if)# rate‐limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Port Trunking
LACP
Switch(config)# lacp group 1 gi8‐10
Group 1 based on LACP(802.3ad) is enabled!
Note: The interface list is fa1,fa3‐5,gi8‐10
Note: different speed port can’t be aggregated together.
54