Westermo PMI-110-F2G - Manual (Page 137)

The configuration and settings explain as following.
LLDP: Select Enable/Disable to enable/disable LLDP function.
LLDP Configuration: To configure the related timer of LLDP.
LLDP Timer: the interval time of each LLDP and counts in second; the valid
number is from 5 to 254, default is 30 seconds.
LLDP Hold time: The TTL (Time To Live) timer. The LLDP state will be expired once
the LLDP is not received by the hold time. The default is 120 seconds.
Local port: the current port number that linked with neighbor network device.
Neighbor ID: the MAC address of neighbor device on the same network segment.
Neighbor IP: the IP address of neighbor device on the same network segment.
Neighbor VID: the VLAN ID of neightbor device on the same network segment.
4.13.6 Ping Utility
This page provides Ping Utility for
users to ping remote device and
check whether the device is alive or
not. Type Target IP address of the
target device and click on Start to
start the ping. After few seconds, you
can see the result in the Result field
.
4.13.7 CLI Commands of the Monitor and Diag
Command Lines of the Monitor and Diag configuration
Feature Command Line
MAC Address Table
Ageing Time
Switch(config)# mac‐address‐table aging‐time 350
mac‐address‐table aging‐time set ok!
Note: 350 is the new ageing timeout value.
Add Static Unicast MAC
address Switch(config)# mac‐address‐table static 0012.7701.0101 vlan 1
interface fastethernet7
mac‐address‐table ucast static set ok!
133