Westermo PMI-110-F2G - Manual (Page 106)

upper layer 3 switch or routers’ DSCP setting.
After configuration, press Apply to enable the settings.
4.8.4 CLI Commands of the Traffic Prioritization
nfiguration Command Lines of the Traffic Prioritization co
Feature Command Line
QoS Setting
Queue Scheduling – Strict Switch(config)# qos queue‐sched
an 8,4,2,1 weight)
S
Priority sp Strict Priority
nd Robin (Use wrr Weighted Rou
witch(config)# qos queue‐sched sp
Queue Scheduling ‐ WRR S )# qos queue‐sched wrr witch(config
Port Setting – CoS
y) (Default Port Priorit
Switch(config)# interface fa1
priority
Switch(config‐if)# qos cos
n (7 highest) DEFAULT‐COS Assign a
Switch(config‐if)# qos cos 7
The default port CoS value is set 7 ok.
Note: When change the port setting, you should Select the specific port
first. Ex: fa1 means fast Ethernet port 1.
Port Setting – Trust
Mode‐ CoS Only Switch(config)# interface fa1
Switch(config‐if)# qos trust cos
102