Westermo PMI-110-F2G - Manual (Page 33)

mode. You can then enter interface configuration mode. In this mode, you can
configure port settings.
The port interface name for fast Ethernet port 1 is fa1,… fast Ethernet 7 is fa7, fast
Ethernet port 8 is fa8.. Gigabit Ethernet port 9 is gi9 and port 10 is gi10. Type the
interface name accordingly when you want to enter certain interface
configuration mode.
Type “exit” to leave current level.
Type “?” to see the command list
Available command lists of the global configuration mode.
Switch(config)# interface fa1
Switch(config-if)#
acceptable Configures the 802.1Q acceptable frame types of a port.
auto-negotiation Enables auto-negotiation state of a given port
description Interface specific description
dot1x IEEE 802.1x standard access security control
duplex Specifies the duplex mode of operation for a port
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
flowcontrol Sets the flow-control value for an interface
garp General Attribute Registration Protocol
ingress 802.1Q ingress filtering features
lacp Link Aggregation Control Protocol
list Print command list
loopback Specifies the loopback mode of operation for a port
mdix Configure mdix state of a given port
mtu Specifies the MTU on a port.
no Negate a command or set its defaults
poe Configure power over ethernet
qos Quality of Service (QoS)
quit Exit current mode and down to previous mode
rate-limit Rate limit configuration
sfp Small form,-factor pluggable
shutdown Shutdown the selected interface
spanning-tree the spanning-tree protocol
speed Specifies the speed of a Fast Ethernet port or a Gigabit
Ethernet port.
switchport Set switching mode characteristics
(VLAN) Interface Configuration: Press interface VLAN VLAN‐ID in global
configuration mode. You can then enter VLAN interface configuration mode. In
this mode, you can configure the settings for the specific VLAN.
The VLAN interface name of VLAN 1 is VLAN 1, VLAN 2 is VLAN 2…
Type exit to leave the mode. Type ? to see the available command list.
The command lists of the VLAN interface configuration mode .
29