RLE FMS V.1.13 - Manual (Page 176)

176 FMS User Guide 800.518.1519
8 Load Firmware and Configuration Data
7 From the HyperTerminal menu select Transfer -> Send File. Use the browse button to
select the FMS firmware file from the computer's directory. The file must be binary and
have a .bin extension. Select the file and upload it using the 1K X-Modem protocol. Then
click Send.
8 A transfer status screen will be displayed. The transfer takes about 10 minutes. Once the
transfer is complete, the transfer status window will automatically close. The
HyperTerminal window will indicate that the upload is complete.
9 From the FCF Boot prompt, type RUN or power down the FMS and restart it to verify that
the new Flash program runs.
10 Press Enter to display the FCF Main Menu and repeat the steps above to erase and
download to the other Flash program chip.
Once the firmware upgrade is complete, disconnect the serial cable and close HyperTerminal.