1 bootloader menu, Bootloader menu, Table 5.3 – RLE FMS V.1.13 User Manual
Page 164: Ip configuration menu

164
FMS User Guide
800.518.1519
5
EIA-232 Interface
5.3.1.1 Bootloader Menu
The bootloader menu is accessed by typing
reset
at the command prompt. This menu is used
to establish IP/TCP and PPP interaction with the network. The FMS must be set up with an IP
address, Subnet Mask, and default router. These addresses can be obtained from your Network
Administrator or IT Department. To enable the SNMP receiving stations, or to create
communities, the FMS MIB, available on RLE’s website, must be loaded on a system(s)
running a Network Operating System (NOS). This MIB is compiled through standard
functions of the NOS. Consult with your Network Administrator for proper installation of the
FMS MIB on the NOS. Once the MIB is loaded, the FMS can be discovered and configured
over the network. For proper operation, the IP addresses configured in the FMS communities
must match the IP addresses on the receiving stations.
Only the administrator's username/password may be changed from this menu. All other Web
users must be changed via the Web interface.
Command Description
Function
mac
Media Access
Control
MAC
will display the current MAC address for the FMS. The
MAC address should never be changed on the FMS, if it
needs to be changed, contact RLE Technologies.
ip
Internet Protocol
IP
is the network address that is part of the TCP/IP protocol
suite for the FMS to communicate over the network.
nm
Subnet Mask
nm
allows users to configure the subnet mask address for
the network.
dg
Default Gateway
dg
allows the user to configure the default gateways/router
address for the network.
ping
ICMP
ping
allows users to send a communication request to
other network device top check for network conductivity.
time
Time
time
displays the FMS current time and date. To enter
manually, type time one space then the current time in 24
hour format, including the seconds. example: hh:mm:ss.
date
Date
date
displays the FMS current time and date. To enter
manually, type date one space then the current time date.
example: mm/dd/yy.
reset
Bootloader
reset
allows the user to return to the bootloader menu
id
Firmware
Identification
id
displays the current firmware file name and file size.
blank
Firmware
fileCheck
blank
displays what firmware files are present in the FMS
memory.
erase prgm
Erase Firmware
erase prgm
allows users to erase the back up firmware file
in the FMS.
Load prgm
xmodem
Load firmware
file via the EIA-
232
Load prgm xmodem
allows users to upload firmware files via
the EIA-232 using a serial packet transfer with a terminal
emulation program.
erase saX
Erase sectors of
memory
erase saX
allows users to erase the specific sections of
memory from the FMS.
Table 5.3
IP Configuration Menu